JAG Arms Extreme Active Braking MOSFET with wiring

Price: $70.00 — In stock at 1 retailer.

Extreme active brake with wiring - professionally designed and manufactured mosfet with motor active braking with 500mm long wires on each side for airsoft electric guns (AEG) - four high quality 1,5qmm (AWG16) power wires covered with silicon insulation and two 0,25qmm (AWG24) signal wires - If you want to use your own wires, choose device without wiring . - Active brake uses the excess energy from the motor to stop it. The braking effect is the most powerful with high torque motor - in weapons with very high rate of fire (ROF) active brake solves multiple shots in semi mode - in semi fire mode piston isn't partially stretched, spring is fully released, parts in mechbox aren't under strain and nozzle locks hop-up chamber in greater part (depends on ROF) - in auto fire mode piston stops in random position due the mechbox design. But this stopping is much faster with active brake - Active brake increases gun rate of fire and battery holds longer - no sparking on switch contacts - device has voltage stabilization for switch mosfet, mosfet is fully opened and makes less heat - specified for common batteries up to 17 V (Ni-xx 8.4V - 14,4V, li-po 7.4V - 14.8V, li-fe 9.9V - 13.2V) - designed for maximum spring M170 - switching mosfet handles up to 2.5 times bigger currents than it's cheaper variant - 5 times better switch on resistance = lower mosfet heating - massive cooler for heat dissipation, it is glued to mosfet - braking mosfet handles up to 2.3 times bigger currents than it's basic variant - doubled number of resistor for reducing braking effect = less resistors heating - easy to understand 6 wires connection - device size 53x21x13mm - coated with lacquer, which protects device against water - in package is heat shrink over device WARNING: Installation of this device leave to expert, who could solder and disassemble airsoft gun. Never user soldering gun!